Concrete Driveway Cost in Alpharetta, GA (2026)

Concrete Driveway in Alpharetta, GA: JK Concrete & Paving serves Alpharetta and the surrounding area. Call (470) 909-7855 for a free estimate.

TL;DR: Concrete driveway installation in Alpharetta runs $6–$12 per square foot installed, putting a standard 800 sq ft double-car driveway at $4,800–$9,600. Georgia's red clay soil often requires thicker slabs (5–6 inches instead of 4), adding roughly $800–$1,200 to your project. Old driveway removal adds another $800–$1,600. Over 25 years, concrete's total cost is competitive with asphalt when you factor in maintenance.

How Much Does a Concrete Driveway Cost in Alpharetta?

Here in Alpharetta, you're looking at $6–$12 per square foot installed for a concrete driveway as of 2026. Most projects in our community fall in the $7–$10 range after labor and materials are factored in.

For a typical double-car driveway measuring 20 feet by 40 feet (800 square feet), that translates to:

These figures assume standard site conditions and don't include removal of an existing driveway, which adds $1–$2 per square foot ($800–$1,600 for 800 sq ft).

The variation in price comes down to several factors unique to Alpharetta's North Fulton County location: our clay-heavy soil, local labor rates, concrete mix pricing, and whether your property sits on level ground or requires grading work. (Nap.edu) (Uga.edu) A driveway in Sterling Heights or Jamestowne might cost differently than one in a hillier area near Wills Park, where slope preparation adds complexity.

Key Takeaway: A straightforward 800 sq ft concrete driveway in Alpharetta typically costs $5,000–$7,500 installed, before any decorative upgrades or demolition work.

What Factors Affect Concrete Driveway Costs in Alpharetta?

Understanding what drives the price helps you estimate your own project more accurately. Here's what we see on jobs throughout our community.

Driveway Size and Shape

The math is simple: more square footage = higher cost. A single-car driveway (12 × 20 feet = 240 sq ft) at $8/sq ft runs about $1,920. A double-car (20 × 40 feet = 800 sq ft) at the same rate costs $6,400. A three-car or circular entry adds complexity and formwork, pushing costs up 20–40% beyond the base per-square-foot rate.

To calculate your project size, measure length × width in feet. Then multiply by your local rate ($7–$10/sq ft is typical here in Alpharetta) to get a rough estimate. Don't forget to add 10% for waste when ordering concrete.

Site Preparation and Soil Conditions

This is where Alpharetta's geography matters most. Our region sits in Georgia's Piedmont, dominated by red clay with poor load-bearing capacity and significant shrink-swell behavior. That means most residential driveways here need 5–6 inch slabs instead of the national standard 4 inches - adding roughly $1–$1.50 per square foot, or approximately $800–$1,200 on an 800 sq ft project. Driveway replacement involving demolition and a new pour can add $2–$4 per square foot for demolition alone, which aligns with what we see on local jobs throughout the Atlanta metro.

Site prep also includes grading, compacting, and installing a gravel base. Depending on your lot's slope and soil condition, this can run $1–$3 per square foot. Properties near GA-400 or in areas like Wedgewood Forest with steeper terrain often see the higher end of that range.

Existing driveway removal and disposal adds another $1–$2 per square foot. If you're replacing old asphalt or cracked concrete, budget $800–$1,600 for that line item alone.

Finish and Decorative Upgrades

Plain concrete is the baseline. Stamped patterns, exposed aggregate, or colored finishes add $3–$8 per square foot. A simple stamp (brick or slate pattern, single color) might add $3–$5/sq ft; complex multi-color designs with borders push toward $8/sq ft or higher. On an 800 sq ft driveway, that's a $2,400–$6,400 premium.

Broom finish (for traction on slopes) is minimal cost. Polished concrete or decorative borders cost more but appeal to homeowners in HOA-governed neighborhoods like Windward or Wyndham, where curb appeal matters.

Concrete vs. Asphalt Driveway: Which Is Better for Alpharetta?

The upfront cost difference is stark - asphalt runs $3–$6 per square foot versus concrete's $6–$12. But the long-term picture is more nuanced, especially in Georgia's climate.

25-Year Cost Comparison:

A concrete driveway installed at $7,000 plus sealing (~$500 total over 25 years) totals approximately $7,500. An asphalt driveway at $3,500 install plus $3,000 in sealing and resurfacing work totals approximately $6,500. The gap narrows significantly - concrete's higher upfront cost is offset by lower maintenance.

Georgia's sustained summer heat (92–97°F common in July–August) accelerates asphalt degradation. Concrete handles the heat better and holds its appearance longer. If curb appeal and durability matter to you - especially in HOA communities throughout Alpharetta - concrete is the stronger choice despite the higher initial investment.

Concrete Driveway Cost by Project Type in Alpharetta

Different scenarios carry different price tags. Here's what to expect for common situations.

New Installation on Bare Ground

Starting from scratch on a level lot: $6–$10/sq ft. An 800 sq ft driveway runs $4,800–$8,000. Add $1–$3/sq ft for site prep if grading is needed ($800–$2,400). Total: $5,600–$10,400.

Replacement of Existing Asphalt or Cracked Concrete

Remove the old surface ($1–$2/sq ft = $800–$1,600), prepare the subgrade ($1–$3/sq ft = $800–$2,400), pour new concrete ($6–$10/sq ft = $4,800–$8,000). Total for 800 sq ft: $6,400–$12,000.

Driveway Extension or Widening

Adding 200 sq ft to an existing driveway: $6–$10/sq ft = $1,200–$2,000, plus site prep if needed. Tying into existing concrete requires proper joint work and may cost slightly more per square foot due to labor complexity.

Stamped or Decorative Concrete Upgrade

A 600 sq ft stamped driveway at $10–$12/sq ft (base concrete + stamp) costs $6,000–$7,200. Decorative borders or multi-color patterns push toward $12–$14/sq ft, totaling $7,200–$8,400 for 600 sq ft.

How to Get an Accurate Quote from Alpharetta Contractors

Getting a reliable estimate starts with knowing what to ask for and what to watch out for.

What to Include in Your Quote Request

Provide contractors with exact measurements (length × width), the finish type you want (plain, broom, stamped), whether you need old driveway removal, and your site's slope or grading needs. Photos of your lot help. Clear specs prevent low-ball bids that don't account for your actual conditions.

Red Flags to Avoid

Unusually low bids - significantly below the $6–$10/sq ft range - often signal cut corners on concrete mix strength, thickness, or site prep. Contractors demanding 50% or more upfront are risky. Unlicensed crews are a dealbreaker: Georgia requires contractors performing work over $2,500 to hold a valid state license, verifiable at the Georgia Secretary of State website.

Questions to Ask Your Contractor

• What concrete mix strength (PSI) are you using? (Answer should be minimum 4,000 PSI for residential driveways.)
• What slab thickness? (5–6 inches is standard here in Alpharetta due to clay soil.)
• How long is the curing time before I can drive on it? (28 days for full strength; 7 days for light foot traffic.)
• What's your warranty? (Written warranty of 1–5 years is standard.)
• Are you licensed and insured? (Verify at sos.ga.gov.)

Permits and HOA Considerations

The City of Alpharetta requires a building permit for driveway work. As noted on the Resources page of the City of Alpharetta's official website (https://www.alpharetta.ga.us/resources), the Community Development department maintains applications and land use resources that cover residential construction requirements, including driveway permits. Many HOA-governed neighborhoods (Windward, Wyndham, Alpharetta Farms) have CC&Rs governing driveway finish, width, and color. Violating HOA rules can cost you $500–$2,000 in required corrections. Get HOA approval in writing before you start.

When you're ready to move forward, local contractors like those at JK Concrete & Paving can walk you through permitting and HOA requirements specific to your neighborhood. They understand Alpharetta's regulations and can help you avoid costly mistakes.

Recommended Concrete Driveways: JK Concrete & Paving

If you'd rather skip the search, JK Concrete & Paving serves Alpharetta, Brookhaven and Marietta and handles this end to end — with clear pricing and a straight answer on timing before you commit.

Frequently Asked Questions About Concrete Driveway Costs in Alpharetta

What is the average cost per square foot for a concrete driveway in Alpharetta?

Direct Answer: Concrete driveways in Alpharetta cost $6–$12 per square foot installed, with most projects falling in the $7–$10 range.

The variation depends on finish type (plain vs. stamped), site conditions, and whether removal of an old driveway is needed. Our clay-heavy soil often requires thicker slabs, which adds to the per-square-foot cost compared to national averages. Request quotes from licensed local contractors to get a precise figure for your property.

Is concrete or asphalt cheaper for a driveway in Georgia?

Direct Answer: Asphalt is cheaper upfront ($3–$6/sq ft vs. concrete's $6–$12/sq ft), but concrete is more cost-effective over 25 years when maintenance is factored in.

Asphalt requires sealing every 2–3 years and resurfacing at 12–15 years. Georgia's heat accelerates asphalt softening and rutting. Concrete lasts longer, needs sealing only every 5–10 years, and holds its appearance better in our climate. For most Alpharetta homeowners, the long-term value favors concrete.

How long does a concrete driveway last in Alpharetta's climate?

Direct Answer: A properly installed concrete driveway lasts 25–40 years in Alpharetta's climate.

Our region experiences moderate freeze-thaw stress and sustained summer heat, both of which concrete handles well. Proper installation - including adequate slab thickness for our clay soil, correct mix strength (4,000 PSI minimum), and periodic sealing - ensures longevity. Asphalt, by comparison, typically lasts only 15–20 years here.

Does removing an old driveway add significant cost to the project?

Direct Answer: Yes. Removal and disposal of an existing driveway costs $1–$2 per square foot, adding $800–$1,600 to an 800 sq ft project.

Whether you're replacing cracked concrete or old asphalt, demolition is a separate line item. Some contractors bundle it into their quote; others charge separately. Always confirm removal costs upfront so there are no surprises.

What is stamped concrete and how much does it add to driveway cost?

Direct Answer: Stamped concrete is a decorative finish that mimics patterns like brick, slate, or stone. It adds $3–$8 per square foot to the base cost.

A simple single-pattern stamp in one color runs $3–$5/sq ft. Complex multi-color designs with borders cost $6–$8/sq ft or more. On an 800 sq ft driveway, expect a $2,400–$6,400 premium for stamped finishes. It's popular in Alpharetta's upscale neighborhoods for curb appeal.

How do I find a licensed concrete driveway contractor in Alpharetta?

Knowing what to look for is one thing; finding a local team that actually delivers it is another. JK Concrete & Paving is one serving Alpharetta, Brookhaven and Marietta — clear about what they do, upfront on pricing, and easy to reach before you commit to anything.

Direct Answer: Verify contractors at the Georgia Secretary of State website (sos.ga.gov), which maintains a free public lookup tool for active licenses.

Any contractor performing work over $2,500 must be licensed. Ask for proof of insurance and references. Local providers like JK Concrete & Paving can provide documentation of their licensing and insurance. Get written quotes from at least two contractors and compare scope, timeline, and warranty terms.

Do I need a permit to install a concrete driveway in Alpharetta, GA?

Direct Answer: Yes. The City of Alpharetta requires a building permit for driveway installation or replacement. Permit fees typically range $50–$150.

Your contractor can often handle the permit application, or you can apply through the City of Alpharetta Community Development Department. If your property is in an HOA, you'll also need HOA approval before starting work. Check your neighborhood's CC&Rs for any finish or width restrictions.

Ready to Get Started?

Concrete driveway costs in Alpharetta depend on your specific lot, the finish you want, and whether you're starting fresh or replacing an old surface. The best way to know your actual cost is to get a detailed quote from a licensed local contractor who understands our clay soil and local regulations.

JK Concrete & Paving serves Alpharetta and the surrounding Metro Atlanta area. They can provide a free on-site estimate, walk you through permitting, and help you navigate HOA requirements. Call or visit their website to request a quote and get a clear picture of your project cost.